Hi guys...it's a long story, but I just got a Diamond Stealth 3000 3D,
4mb VRAM-PCI card. (I wanted a rendition card, but I got this for free,
and as I said, it's a long story...). Anyway, it replaces a generic 1mb
card and frankly I don't see a ton of improvement, if any.
I ran the "test" in the setup page, and it upped the display rate (that
was shown on the setup screen, not the actual display rate). I
reconfigured the univibe, but it only showed a "s3 super VGA (unknown
s3) with 2 mb - Generic 8-bit Dac - Discrete clock selection". I'm about
to delete the univibe config file and try that...
Can anyone set me straight and tell me how to get the most out of my
card? Or how to make sure NCR2 is set to use it well? Did I***up by
not getting a rendition? Should I run univibe? I'm running a P90 with 24
MB of ram if it matters. Thanks in advance for your help......
Lou B.
Rustbucket Racing