rec.autos.simulators

by **Varmint2** » Tue, 06 Oct 1998 04:00:00

Hi Group,

I was fooling around switching back and forth between my Sii220 and 12meg
V2. I was checking monitor status and my refresh rates were quite low and not
what I believe I have them set to. Can GPL override my settings ??

Should be 800x600 75mgz on Sii220
Should be 800x600 85mgz on 12meg V2

Am I missing something somewhere ?

Do I not really understand onscreen monitor status ?

BTW frame rates aren't much differn't in training mode. I expected the V2 to be
much faster.

Thanks, Dave

by **Eric T. Busc** » Tue, 06 Oct 1998 04:00:00

GPL should use the refresh rates that you have set in your display
properties for each resolution.

- Eric

by **Lou** » Wed, 07 Oct 1998 04:00:00

I have not been able to adjust my refresh rate in the display properties of
my M3D 2 since I upgraded the drivers. I made sure I downloaded the correct
monitor settings and the refresh slider still stay on 60hz. My monitor can

Lutrell,
Dsr#74 :-)
http://www2.scca.com/amateur/club_racing/runoffs/photogal/dsr-74.jpg

by **Clark Arch** » Sun, 11 Oct 1998 04:00:00

I have experienced the same problem with the stuck M3D 2 card.
Interestingly, I just went and tried once more after reading your
message and it finally worked. Strang huh?

Clark A.

>I have not been able to adjust my refresh rate in the display properties of
>my M3D 2 since I upgraded the drivers. I made sure I downloaded the correct
>monitor settings and the refresh slider still stay on 60hz. My monitor can

>Lutrell,
>Dsr#74 :-)
>http://www2.scca.com/amateur/club_racing/runoffs/photogal/dsr-74.jpg

>>But like Eric said, GPL shouldn't change refresh rates itself, it should be
>>what's set in your display properties for each card. And unless you're
>>running a 350-450, I'd imagine the cards would be close in performance for
>>GPL.

>>Ken

rec.autos.simulators

GPL refresh rates

GPL refresh rates

GPL refresh rates

GPL refresh rates

GPL refresh rates