rec.autos.simulators

Could someone please tell me how to setup the ECCI wheel and pedals in
WIN95?I have the adapter cable plugged in but I can't get my wheel and
pedals to work.I dont see a wheel and pedal setup in the Win95 joy stick
calibration setup screen.Do I use custom or what?I usualy drive under Dos
but I'm trying to get ready for the NRO and you have to use Win95 for
Ten.Could someone please explain this to me?I know allot of you use Win95
to drive Nascar 2 so I'm sure this won't be a prob.We will all have to use
it in the NRO.

Thanks,Eric
P.S Here is my e-mail address if you would rather reply by it:(

Eric,

With the adapter cable your early CDS system will calibrate as a single
two axis joystick (late model CDS2 units need no adapter) First if your
pedal unit has a switch on the left side of the housing switch it to the
down position. In the Windows 95 joystick setup screen you need to select
CUSTOM JOYSTICK; and then select 2 AXES and FOUR BUTTONS. Also select IS A
RACE CAR COMNTROLLER. When going through the calibration steps it is
important to follow EXACTLY what the routine prompts you to do... a common
mistake is not setting the center point twice... once at the very
beginning of calibration and again at the end. If you only set center once
it will not work. This should get you through, but if it does not, just
contact ECCI by E-mail and we will be happy to help you further if needed.

A Cers
ECCI

Bryan

Use custom and that will give you choice of race car controller, then
follow instructions in Win and ECCI booklet. I have them, great
system.