lost the info. I have a USR 56K V90 modem. What string can I use to run it
at 33.6?
Jesse
Jesse
Below pasted from the 3COM/USR V.90 tech manual: &N0 Connection speed is determined by the remote modem. Steve B.
---------------------------------------------------------------------------
&Nn
Sets connect speed. If connection cannot be made at this speed, the
modem will hang up. When used in conjunction with &Un and &Un is
greater than 0, &Nn sets the ceiling connect speed. &Un sets the floor
connect speed (See also the table in the &Un section.)
&N1 300 bps
&N2 1200 bps
&N3 2400 bps
&N4 4800 bps
&N5 7200 bps
&N6 9600 bps
&N7 12,000 bps
&N8 14,400 bps
&N9 16,800 bps
&N10 19,200 bps
&N11 21,600 bps
&N12 24,000 bps
&N13 26,400 bps
&N14 28,800 bps
&N15 31,200 bps
&N16 33,600 bps
&N17 28,000 bps
&N18 29,333 bps
&N19 30,666 bps
&N20 32,000 bps
&N21 33,333 bps
&N22 34,666 bps
&N23 36,000 bps
&N24 37,333 bps
&N25 38,666 bps
&N26 40,000 bps
&N27 41,333 bps
&N28 42,666 bps
&N29 44,000 bps
&N30 45,333 bps
&N31 46,666 bps
&N32 48,000 bps
&N33 49,333 bps
&N34 50,666 bps
&N35 52,000 bps
&N36 53,333 bps
&N37 54,666 bps
&N38 56,000 bps
&N39 57,333 bps
---------------------------------------------------
THERE YOU GO!
Remove "edy" from address for email
--
Doug Gordon
(remove "nospam" from e-mail address)
Hey guys, I have asked this before but my modem died for a while so I have
lost the info. I have a USR 56K V90 modem. What string can I use to run it
at 33.6?
Jesse
Ya know thats curious. I've only done online a few times so far, but
all I've done is lower the port buffer settings and lower my graphic level
to achieve near 36 fps and I haven't had any "modem" problems. As long
as the framerate was up there, I haven't been disconnected. I MUST
emphasize
again however, that my online time is extremely limited so far.
dave henrie
--
George Sandman
Sponsored by PDPI L4 Digital Gamecard http://www.racesimcentral.net/
Stealth Racing #1 http://***sys.com/stealthracing.html