Where can I get the latest MS joystick port
drivers?
--
Pat Dotson
IMPACT Motorsports
http://www.racesimcentral.net/
> > Has anyone else solved lockups by re-installing TEN?
> Turns out that didn't solve the problem... I had
> my controls mapped to keyboard just for testing and
> everything worked OK. As soon as I switched to
> wheel and pedal controls, it locked up :(
> Where can I get the latest MS joystick port
> drivers?
So have you tried running non-rendition ?
Beers and cheers
(uncle) Goy
So, is there some incompatability between the
K6-2 and my Screamin' 3d, or rendition cards
in general? I guess I'm stuck with software
mode until I buy a new card.
What surprises me is that I still get 30 fps
w/all details on in software mode. It doesn't
look as good but fps is fine.
--
------------------------------------------------------
IMPACT Motorsports
http://www.impactmotorsports.com/pd.html
------------------------------------------------------
> I don't know why, but that is the only thing I
> hadn't tried. Last night I did and it ran fine
> with no lock-ups all night.
> So, is there some incompatability between the
> K6-2 and my Screamin' 3d, or rendition cards
> in general? I guess I'm stuck with software
> mode until I buy a new card.
Could be that your controller and rendition card uses the same dma, just
a wild guess on my part, or an I/O conflict that doesn`t show
I`ve come across this with nework cards, couldn`t get a PC to log onto a
Novell network, switched the I/O adress and it worked fine, and the card
was not faulty, it was just that the conflict didn`t show up, have
encountered that one a couple of times since, but it`s a shot in the
dark really
At some tracks, Bull Run for instance, you will have better frame rate
in plain software mode, even on a Hercules Thriller 8MB, go figure, it
stutters like hell in some turns
Beers and cheers
(uncle) Goy
"Team Mirage" - www.teammirage.com
> I don't know why, but that is the only thing I
> hadn't tried. Last night I did and it ran fine
> with no lock-ups all night.
> So, is there some incompatability between the
> K6-2 and my Screamin' 3d, or rendition cards
> in general? I guess I'm stuck with software
> mode until I buy a new card.
Could be that your controller and rendition card uses the same dma, just
a wild guess on my part, or an I/O conflict that doesn`t show
I`ve come across this with nework cards, couldn`t get a PC to log onto a
Novell network, switched the I/O adress and it worked fine, and the card
was not faulty, it was just that the conflict didn`t show up, have
encountered that one a couple of times since, but it`s a shot in the
dark really
At some tracks, Bull Run for instance, you will have better frame rate
in plain software mode, even on a Hercules Thriller 8MB, go figure, it
stutters like hell in some turns
Beers and cheers
(uncle) Goy
"Team Mirage" - www.teammirage.com
I've found that using the -4 switch offline works very well. Especially
at
bullrun, takes all the hiccups right out. Don't know if that option is
available
via NROS since I've never done the TEN deal. Later.
dave henrie
