Hello Folks,
I am using a TM PFCS to control my F1 car in the F1RS (with v1.09 patch)
but my F1 car cannot turn enough even I push my joystick all the way
right (or left). For anything higher than a slow turn, my car would not
turn enough (i.e., understeer) and ends up on the gravel. I tried
different sentivisity setting & my stick was calibrated properly. Any
other settings that I can try.
Thanks.
Tony
Hi Tony,
I had the same problem and updated my Win95 to Win95 A (service pack
available for download at Microsoft). No more problems since.
Joerg
Three things spring to mind straight away?
1) Make sure you are not just going *too fast* for the corner!!!
2) The default set-ups suffer badly from understeer, so you need to
reconfigure the car set-ups, eg:- add more front wing, or reduce rear
wing, lower ride height, raise and lower springs as appropriate, etc.
(Or just download a few car set-ups from the net)
3) Increase the steering angle to get the car to turn in more. NB-
this can lead to even worse understeer at fast corners if you overdo
it?
8?)
*Peter* 8-)
(NB: remove asterix to e-mail)
