You may need to do a fresh install, just to be sure all is intact. FWIW, the
patch needed is ICR_102.EXE, and needs to be run (as you probably know) from
the main ICR2 directory. With a fresh install (full, not partial), the patch
should work fine.
Note: Make sure to make backups of all your setups and carsets!
The other patches needed (if you're into painting) are the files for the ICR2
Paintkit (not patched with ICR_102). The files are PATCHPKT.COM and
PKIT102.EXE. You can download them from most sites, but here's a link to get
you going:
ICR_102.EXE:
http://www.simracing.com/downloads/pc/patches/sierra/icr_102.exe
PATCHPKT.COM:
http://www.simracing.com/downloads/pc/patches/sierra/patchpkt.com
PKIT102.EXE:
http://www.simracing.com/downloads/pc/patches/sierra/pkit102.exe
Hope this helps.
Cheers!
Marc
> I know this is an oldy, I just had to get it back out after being
> dissapointed with MS's CPR. Anyway, I tried to run the patch for version
> 1.0.0 and it patched quite a few files, then died with an error that said
> that a similar file had been found and that nothing would be updated.? I
> did go into all of my track dirs and made sure that the .txt files were not
> marked "read only". It's been a while since I had this program running,
> could anyone give me the proper procedure for running the patch? Thanks!
> --
> Scott Golden
> Lexis-Nexis
> Product Packaging
> (937)865-6800 x5354
--
Marc J. Nelson
SimRacing Online - http://www.simracing.com/
* Switch confused.net with concentric.net to reply...Confused-yet? *
