rec.autos.simulators

> Can anyone help?

> I've owned TOCA for some time with no problems, but since upgrading to
> directx6 I can't get it to work properly. When I go to the circuit select
> screen, it shows all tracks darkened and after a short time it shuts itself
> down, I sometimes get a message saying low video memory, I've set it up to
> use my 3d 2000 and Orchid Righ 3dfx graphics cards but it does exactly the
> same with both. I tried re-installing TOCA a few times with no success. I'm
> a little short on disk space can this cause problems?

>I've owned TOCA for some time with no problems, but since upgrading to
>directx6 I can't get it to work properly. When I go to the circuit select
>screen, it shows all tracks darkened and after a short time it shuts itself
>down, I sometimes get a message saying low video memory, I've set it up to
>use my 3d 2000 and Orchid Righ 3dfx graphics cards but it does exactly the
>same with both. I tried re-installing TOCA a few times with no success. I'm
>a little short on disk space can this cause problems?

> Hi Yall,
>  Since upgrading to DX 6 TOCA takes a long time to load. I thought it locked
> up but waited a min. or 2 and i started. When going to each track it also
> does this. I also get the dark track layout when selecting the track at the
> track selection screen but not in the screen as the track loads. I run  a
> P200,64Mb ram, STB riva 128, and Monster 3d in Win 98.

> > Hi Yall,
> >  Since upgrading to DX 6 TOCA takes a long time to load. I thought it locked
> > up but waited a min. or 2 and i started. When going to each track it also
> > does this. I also get the dark track layout when selecting the track at the
> > track selection screen but not in the screen as the track loads. I run  a
> > P200,64Mb ram, STB riva 128, and Monster 3d in Win 98.

> I seem to have this same problem! Thought it was just my system.
> --

>     ,,,
>    (o o)
> o00o-(_)-o00o

> Mike Z was here!
> Remove *** to reply

>I've owned TOCA for some time with no problems, but since upgrading to
>directx6 I can't get it to work properly. When I go to the circuit select
>screen, it shows all tracks darkened and after a short time it shuts itself
>down, I sometimes get a message saying low video memory, I've set it up to
>use my 3d 2000 and Orchid Righ 3dfx graphics cards but it does exactly the
>same with both. I tried re-installing TOCA a few times with no success. I'm
>a little short on disk space can this cause problems?