but the suction cups keep popping off when im turning, any ideas on
how to fix this?
Toms Vaporware Review
http://www.racesimcentral.net/ or http://www.racesimcentral.net/
Home of the "UNBIASED" review!
Toms Vaporware Review
http://www.racesimcentral.net/ or http://www.racesimcentral.net/
Home of the "UNBIASED" review!
>> Im having a problem keeping my wheel in place. I clamp it down
>>but the suction cups keep popping off when im turning, any ideas on
>>how to fix this?
>I find I get better results if I moisten the suction cups before
>sticking them down. It helps make a better seal.
>---
>Jet Jaguar
>I have a spam blocking address. Replying to me is like pulling teeth.
>Visit my crappy home page at http://home.att.net/~chmilnir/
>MSTie #54297
>The suspense is terrible. I hope it will last.
Toms Vaporware Review
http://www.tomsvaporware.com or http://tomsvaporware.com
Home of the "UNBIASED" review!
>Toms Vaporware Review
Are you also using the Clamps?
Joel Willstein
I had the same problem. What I did:
I removed the suction cups and placed bolts through the holes (6 mm). To
prevent damaging the plastic, I put small
pieces of woon between the plastic and the head of the bolt.
Then I made two holes in the table for the bolds and fastened them by
butterfly nuts so I can remove the wheel
quickly.
greetings,
Han
On both my GP1 and T1 (same steering-wheel casing) I have this
weird-but-great system. You open up the case, add in a few bolts, and
attatch a keyboard-sized piece of plywood to the bottom. Then you drill a
hole on either end and get these hand-screw things (like a big bolt with a
plastic handle) and also drill two matching holes in the desk. You get
these little threaded things that you hammer into the holes and then put it
all on the desk. Not a millimeter of movement! Maybe I should start
selling them as kits...
--
Kirk Lane
Tempe, AZ
ICQ: 28171652
RMRL #119
>Toms Vaporware Review
>http://www.tomsvaporware.com or http://tomsvaporware.com
>Home of the "UNBIASED" review!