Race Sim Central
Rec.Autos.Simulators Archive

Nascar 99 Question

4 posts by 4 people · 22 May 1999 - 23 May 1999

J Kopp 22 May 1999#469499
I have just recently loaded NR99 onto a new system I have built. It is a Celeron 400, 64 MB ram, Creative Riva TNT AGP w/16 mb, and SoundBlaster Live. The game runs fine in Win95, but when I try to run in DOS, My monitor (19" CTX Ultra Screen) displays the following error message - "Signal Out of Range, 92.5KHz 173+Hz". I also hooked up my old monitor - and all I saw was garbled colors. I have tried updated graphics drivers from creative, and also detonator...all to no avail. Also, when I run soundset, I select soundblaster, input my settings, hit test - then I do hear the audio. After the audio plays, the system locks so that I can't exit and save the settings. It also won't let me select the settings and exit without testing. mention hopefully avoid the crashes/lockups I have been seeing when running in Win95. Anyone with any suggestions, I would greatly appreciate the input/help. I have posted at Tom's Hardware, Sierras Motorsports Forum, and no one has offered any help. Please - any suggestions would be a big help - I don't know what to to anymore. Thank you
Your monitor is not capable of running at the refresh rate that your 3dfx card is running at bud, you need to set the 3dfx card lower, my monitor runs from 60hz to 85hz, my 3dfx card runs from 60hz to 120hz. -- Tim "Calm Down" Wheatley ________________________________________________ Tim Wheatley "Yellow menacing helmet in the mirror" http://start.at/igps_stats IGPS - Ferrari Challenge - UKGPL - Summer Cup Driver http://drive.to/grandprixlegends http://website.lineone.net/~nascar ________________________________________________
Ricky L 22 May 1999#469501
Quoted text (15 lines)>I have just recently loaded NR99 onto a new system I have built. It >is a Celeron 400, 64 MB ram, Creative Riva TNT AGP w/16 mb, and >SoundBlaster Live. The game runs fine in Win95, but when I try to run >in DOS, My monitor (19" CTX Ultra Screen) displays the following >error message - "Signal Out of Range, 92.5KHz 173+Hz". I also hooked >up my old monitor - and all I saw was garbled colors. >I have tried updated graphics drivers from creative, and also >detonator...all to no avail. >Also, when I run soundset, I select soundblaster, input my settings, >hit test - then I do hear the audio. After the audio plays, the >system locks so that I can't exit and save the settings. It also won't >let me >select the settings and exit without testing.
It sounds like a problem with the refresh rate in dos. Try setting your refresh rate to adapter default. See if that helps. As for your soundcard problem, can you do autodetect w/o lockup? I have SBLive value, and I use sb16 instead of sb. Check to make sure that SBLive is not sharing IRQ with other devices, like graphics cards. I've read that SBLive doesn't like sharing irq with other devices. Ricky
Mortado 23 May 1999#469668
I know your problem is already fixed from your reply on Sierra's Motorsports board, but thought I'd post the answer here just in case anyone else is suffering from the same problem- >I have just recently loaded NR99 onto a new system I have built. It >is a Celeron 400, 64 MB ram, Creative Riva TNT AGP w/16 mb, and >SoundBlaster Live. The game runs fine in Win95, but when I try to run >in DOS, My monitor (19" CTX Ultra Screen) displays the following >error message - "Signal Out of Range, 92.5KHz 173+Hz". I also hooked >up my old monitor - and all I saw was garbled colors. The TNT boards will NOT work with DOS programs like Nr1999 until you have done two things- configured the sound and removed the introduction video. You can remove the introduction video by remming out the smackply line in NR1999.bat. Not needed let me guess. Your settings give an IRQ of 2, correct? If you go to the Device Manager and look at the properties of your computer, you will probably find that the SB 16 emulation is really on IRQ 9, which NR1999/N2 can not use. Reassign the resource to 5, 7 or 10 and change the set blaster line in your autoexec.bat accordingly. You should be good to go at that point, unless you have another device using the new IRQ you have selected. I have no idea why the Creative cards do this, but I have found it to be quite common, on all of their sound cards ranging from SB 16 to the Lives. Other sound cards do not seem to experience the "wrong IRQ" phenomenon. Keep in mind this only happens on some of the cards, not all of them so it is probably the wonders of "Plug and Pray" interacting with Creative's drivers causing this. One the sound has been properly configured and the video has been disabled you should be good to go. Cheers, Chris "How can you run from a dead person, unless you're dead yourself?" -Venus in Furs --Horrornews--Horrorchat--Reviews--General filth-- Mortado's Page of Filth http://www.shadows.com/mortado/

Sponsors

Affiliate Links

Sim Gaming Expo MOZA Racing Sim-Lab Fanatec TrakRacer Asetek Internet Privacy From NordVPN Dreamhost Capital One Credit Card Application Fanatical CDKeys Amazon Amazon UK Project Motor Racing iRacing Get your racing gloves, boots and more from Demon Tweeks. Enlist at Roberts Space Industries, developers of Star Citizen and Squadron 42


Back from the ashes since July, 2019. First created in 2001 with the merger of Legends Central (founded 1999) and simracing.dk.

A site by a sort of sim racer, for sim racers, about racing sims. News and information on both modern and historic sim racing software titles.

All products and licenses property of their respective owners.


Facebook Threads Bluesky Twitter Mastodon Instagram YouTube Tiktok Twitch Reddit Google News Apple News Subscribe via WordPress Flipboard eBay

Race Sim Central © 1999-2026 | Some links pay RSC a commission. Advertising does not equal endorsement.Cookie Policy