quick question MS FF wheel URGENT!! :)

Does the pedal base support split axis?

Yes, but it's done in the MS software, not a switch on the hardware. I don't have one myself, but have seen one set up. Steve B. remove "edy" from address for email

Yes. I own this wheel. Split pedals work great in GPL. Doug >Does the pedal base support split axis?

> Yes. I own this wheel. Split pedals work great in GPL. Sorry if I am missing the obvious but how do I enable split axis? GPL sees it only as a single axis :( Paul..

Is the CART racing included the 1.1 version or should I download the patch? TIA

Paul, got to the setting tab in the MS Wheel control panel. UN-check the link axis box (or similar). Go to GPL and recalibrate, it should give you full throw on 2 separate axis now. G. Patricks

Paul You need to setup a profile with the Pedal set as "Separate". This is located on the "Settings" page 2nd page) of the MS Sidewinder Profile Editor. To do this, start a new profile and immediately go to the "Settings" page. Don't do anything on the 1st page. Set the pedals to separate and then save the profile as "GPL" or whatever. Now go into GPL and calibrate the wheel and pedals. Make sure this profile is active when you race in GPL. That's it! Doug >> Yes. I own this wheel. Split pedals work great in GPL. >Sorry if I am missing the obvious but how do I enable split axis? >GPL sees it only as a single axis :( >Paul..

yes

> Paul, got to the setting tab in the MS Wheel control panel. UN-check > the link axis box (or similar). Go to GPL and recalibrate, it should > give you full throw on 2 separate axis now. OK I give up :( I really cant see this checkbox! I have only one checkbox in the wheel control panel and that is for "Map forces from Y axis to X axis" that doesn't seem to work. This checkbox is under the settings tab. Is there some new version of the software what I dont know about? I am using 3.02 now! Please help.. Paul..

Quoted text (9 lines)

> Paul > You need to setup a profile with the Pedal set as "Separate". This is > located on the "Settings" page 2nd page) of the MS Sidewinder Profile > Editor. To do this, start a new profile and immediately go to the "Settings" > page. Don't do anything on the 1st page. Set the pedals to separate and then > save the profile as "GPL" or whatever. Now go into GPL and calibrate the > wheel and pedals. Make sure this profile is active when you race in GPL. > That's it!

Phew thanks Doug. It's just that my reseller was advertising it as version 1.0 and had it a little bit cheaper. Then I thought that I had bought a lemon that was superseded already :) Paul..

Yep. In software. -Larry > Does the pedal base support split axis?