Does anybody know how to save the settings
when using the generic input device?
No savingprobs when using direct input.
Knudse.
.
% Does anybody know how to save the settings
% when using the generic input device?
% No savingprobs when using direct input.
Saving what settings?
--
**************************** Michael E. Carver *************************
Upside out, or inside down...False alarm the only game in town.
=-=-=-=-=-=-=-=-=-=-=-=-=-=-=<[ /./. [- < ]>=-=-=-=-=-=-=-=-=-=-=-=-=-=
Calibration of wheel, setup for gear up/down,
clutch, looking left/right, raise hand,
view pit board, steering linearity ....
... did I leave anything out ???
Knudse.
If in doubt ... overtake.
.
I haven't had any trouble with that. You DO have to reassign the functions
when you switch back & forth from direct input to generic, but then the
settings are retained until you switch again. Are yours not?
Steve B.
Are you using ACM Game Card? I have the same problem when I'm using that
card. If I use sb16 gameport it's OK!
Borut
Quoted text (16 lines)
>> % Does anybody know how to save the settings >> % when using the generic input device? >> % No savingprobs when using direct input. >> Saving what settings? >Calibration of wheel, setup for gear up/down, >clutch, looking left/right, raise hand, >view pit board, steering linearity .... >... did I leave anything out ??? >Knudse. >If in doubt ... overtake. >.Nope.
Have to reconfigure/calibrate every time
I enter GPL ....
That is, only when using generic input ...
Knudse.
Quoted text (10 lines)
> >Calibration of wheel, setup for gear up/down, > >clutch, looking left/right, raise hand, > >view pit board, steering linearity .... > >... did I leave anything out ??? > I haven't had any trouble with that. You DO have to reassign the functions > when you switch back & forth from direct input to generic, but then the > settings are retained until you switch again. Are yours not? > Steve B.No -
Using the gameport on my Turtle beach montego.
Knudse.
> Are you using ACM Game Card? I have the same problem when I'm using that
> card. If I use sb16 gameport it's OK!
I've seen a couple of times when changing from generic input to direct input
GPL lost some of my settings for wheel left, right, accel, break etc..
i.e. it didn't know that Joy1 X-axis was wheel left-right..
All I did was redo which control I wanted for each of those settings again.
Hope that works for you.
Seeyas on the track.
--John (Joao) Silva
