Hi Group,
I was fooling around switching back and forth between my Sii220 and 12meg
V2. I was checking monitor status and my refresh rates were quite low and not
what I believe I have them set to. Can GPL override my settings ??
Should be 800x600 75mgz on Sii220
Should be 800x600 85mgz on 12meg V2
Am I missing something somewhere ?
Do I not really understand onscreen monitor status ?
BTW frame rates aren't much differn't in training mode. I expected the V2 to be
much faster.
Thanks, Dave
GPL should use the refresh rates that you have set in your display
properties for each resolution.
- Eric
I have not been able to adjust my refresh rate in the display properties of
my M3D 2 since I upgraded the drivers. I made sure I downloaded the correct
monitor settings and the refresh slider still stay on 60hz. My monitor can
Lutrell,
Dsr#74 :-)
http://www2.scca.com/amateur/club_racing/runoffs/photogal/dsr-74.jpg
I have experienced the same problem with the stuck M3D 2 card.
Interestingly, I just went and tried once more after reading your
message and it finally worked. Strang huh?
Clark A.
