F1C Melbourne and Braking Problems

I recently picked up F1C and started racing at Melbourne. One thing that I have found very frustrating is that I always end up retiring with brake failure. If I try and back off on the brakes to conserve them, I loose a LOT of time. It seems to me that the brake wear rate in this sim is artifically high. Is there anything that can be done (such as an .ini setting) that can aleviate this? Thanks.

I assume you've increased the brake duct in the car setup? Failing that, you just need to try not to brake and accelerate at the same time too much...

Quoted text (7 lines)

> > Is there anything that can be done (such as an .ini setting) that can > aleviate this? > > Thanks. > >

In the options, change the damage setting from "Time Scaled" to normal. dh

Joe Blow wrote:

Quoted text (8 lines)

> I recently picked up F1C and started racing at Melbourne. One thing > that I have found very frustrating is that I always end up retiring > with brake failure. If I try and back off on the brakes to conserve > them, I loose a LOT of time. It seems to me that the brake wear rate > in this sim is artifically high. > > Is there anything that can be done (such as an .ini setting) that can > aleviate this?

Barrichello had the same problems today :-) > Thanks.