Problem: F1RS Controller Configuration

Hi. I have a CH Racing Wheel which I'm using with my CH Pedals. I've set it up as a Racing Wheel, and also F1RS sees everything, and have the 1.09 patch. Everything is fine, but I can't seem to get the controls to work properly. Either the brakes are too soft, or lock up when I touch them, or the acceleration is almost digital. I've adjusted the sensitivity, checked the calibration, tried the dead zone fix, but it isn't quite right. Could someone with a similar configuration please help me out? Thanks, Marvin -- -------- Please remove the obvious spam-blocking from my e-mail address when replying. --------

Quoted text (10 lines)

> Hi. > I have a CH Racing Wheel which I'm using with my CH Pedals. I've set it up > as a Racing Wheel, and also F1RS sees everything, and have the 1.09 patch. > Everything is fine, but I can't seem to get the controls to work properly. > Either the brakes are too soft, or lock up when I touch them, or the > acceleration is almost digital. I've adjusted the sensitivity, checked the > calibration, tried the dead zone fix, but it isn't quite right. > Could someone with a similar configuration please help me out?

I use the CH Pedals, too. While an F1 car should have a touchy gas pedal ;^) Did you set the sensitivity to 100%? It sounds illogical, but this works for me. l8er ronny -- How to get rid of censorship in German game releases <http://www.gamesmania.com/german/maniac/freedom/freedom.htm> |\ _,,,---,,_ I want to die like my Grandfather, ZZZzz /,`.-'`' -. ;-;;,_ in his sleep. |,4- ) )-,_. ,\ ( `'-' Not like the people in his car, '---''(_/--' `-'\_) screaming their heads off!

Just this afternoon, I used almost all of my tax refund to get a Monster 3DII. Installation seemed to go fine. Afterward, I ran ICRII for a while and a couple of other flight and driving sims. But somewhere during the course of uninstalling a few games and installing a new one, or changing my game controller, I screwed SOMETHING up. When I try to run ICRII or SODA, my monitor clinks two or three times like it's changing resolution or something, and I get two identical distorted horizontal windows across the screen. Anybody know what I did and how to fix it. My knowledge of this end of things is very limited. I considered myself fortunate to have installed the board without electrocuting myself. :-/ Please, help! Thanks! Kurt