When you say converter, is that a resistor or is it a dongle of some
sort that switches a couple leads around in the joystick port/cable? I
have a set of pedals (CH Pedals) that I want to use with this wheel.
Can I reroute a couple pins on the joystick cable to run along this
axis for Win 95? Needless to say I am quite a rookie at this, and need
a little coaching. Much thanx.
BT Nagle
Most sincerely from the desk of BT Nagle
"I reckon so..." - Clint
No spamming, please
Quoted text (13 lines)
>>Just a quick question. I just patched my IndycarII game to Win95 >>version. I noticed in the notes on the readme that a "single axis >>controller will not work in Win95". To me, that tells me that the nice >>homemade wheel I made using a single pot will not work correctly in >>Win95. Does anyone else have any experience with this condition? Do I >>have to wire a dummy pot to the wheel in order to calibrate with >>Win95? Any insight would be appreciated. Thanx!! >I have a home made wheel with wiring that basically follows the T2 and >it works. You have to use a converter to put the brake/gas on the >other axis of the 1st joystick for Win95 to recognise it as AFAIK. >This converter comes with the T2 but I dont know where to buy one >retail, shouldnt be real hard to make one though.>>I have a home made wheel with wiring that basically follows the T2 and
>>it works. You have to use a converter to put the brake/gas on the
>>other axis of the 1st joystick for Win95 to recognise it as AFAIK.
>>This converter comes with the T2 but I dont know where to buy one
>>retail, shouldnt be real hard to make one though.
I too have a homemade wheel. I used a cable from a Suncom joystick and
went to thier website (url unknown do search) for the pinout. I then
determined which wire's I needed to use and simply added another pot on
those wires. Win-95 no longer tells me that my joystick is improperly
connected when I have my wheel attached.
Did you work your stearing shaft straight onto the pot??? I had mine
that way and really hated it. Eventually added some gears, from a
differential set for an RC car, and I LOVE this. I have over 540 degrees
of total rotation available to me. I calibrate about 270 degrees and it
works great. It's also easier on the pots and I don't have to replace them
as often. More of a hassle to do so though. ;-)
Good Luck
Steve
+-----------------------------------+-------------------------------------+
| All the worlds a stage, | NASCAR Drivers that I root for. |
| and there's a comedy playing. | Dale Earnhardt #3 |
| May as well enjoy the show. | Mike Skinner #31 |
| | Rusty Wallace #2 |
| Steve Sarlls | Micheal Waltrip #21 | +-----------------------------------+-------------------------------------+
+-------------------------------------------------------------------------+
