I have a t2 and in order to make it not flip over and move around on the floor
when I pressed too *** the pedals I did this....
Get a sheet of beaver board (3/8 thick). (4x8 sheet)
cut it about 6 feet long by 4 feet wide.
----------------------------
_______________
I then drilled holes in the outside lip of the pedal unit in the corners and
drilled them through the beaver board and attached them with bolts.
This way I can put my chair on top of the board and it holds the pedals in
place. If you make the sheet less than 6 feet long half of the chair slides
off and it can be a pain.
This works great for me.
Tim Daley
Expertec Corporation (313)451-2272
Providers of Software Solutions and Expertise
http://www.expertecinc.com
"The best things in life....aren't THINGS!!!
__________________________________________________
What I did to remedy my T2 pedals flipping over was to drill two holes in
the base of the pedal unit on the side opposite my pedals (thin side) . I
then simply screwed it into the floor. My computer is in a carpeted room.
This method is not recommended for a concrete floor. Ha-ha
>What I did to remedy my T2 pedals flipping over was to drill two holes in
>the base of the pedal unit on the side opposite my pedals (thin side) . I
>then simply screwed it into the floor. My computer is in a carpeted room.
>This method is not recommended for a concrete floor. Ha-ha
Here's my solution.
I used a piece of wood as deep as the T-2 and 2.5 times wide. In it's
previous life it was a small shelf. Then I used black duct tape to
mount the T-2. Finally, I attached velcro strips to the bottom side.
(carpeted floor)
With the combination of weight and velcro, the thing does not budge.
>I used a piece of wood as deep as the T-2 and 2.5 times wide. In it's
>previous life it was a small shelf. Then I used black duct tape to
>mount the T-2. Finally, I attached velcro strips to the bottom side.
>(carpeted floor)
>With the combination of weight and velcro, the thing does not budge.
I was a little more primitive in my solution. I have a long wooden
VHS cassette holder on my floor, packed with tapes. I simply moved
it so one end sits on the capacious left side of the pedal unit.
Et voila!
--
http://members.cruzio.com/~keeper/toons.html - Contemporary WB cartoons info
http://www.armory.com/~keeper/midi.html - My own MIDI music and arrangements
