Hello everyone,
When I install the 1.2 patch should it go through an installation process?
My screen just clicks, goes black and then end up back where I started, not
telling me that anything has been installed.
Regards,
Steve
After patching, go to gpl directory leftclick gpl.exe /properties /versno
info.... if it says 1.2.0.1 all is fine
SZ
Thanks. All OK
Is there a site that has all the editors? I have been dying to have a go at
these but have been a bit scared. I think the time is right.
Regards,
steve
"Stefan Zscharnack" <[email hidden]> wrote in message
news:brnX6.2372$[email hidden]...
> After patching, go to gpl directory leftclick gpl.exe /properties /versno
> info.... if it says 1.2.0.1 all is fine
> SZ
>
>
The GPLEA site and their forum would be a good place to start
http://www.kotr.de/org/
"Russ" <[email hidden]> wrote in message
news:pknX6.71849$[email hidden]...
> Thanks. All OK
>
> Is there a site that has all the editors? I have been dying to have a goat
> these but have been a bit scared. I think the time is right.
>
> Regards,
>
> steve
In article <oDmX6.71811$[email hidden]>, "Russ"
<[email hidden]> writes:
>Hello everyone,
>
>When I install the 1.2 patch should it go through an installation process?
>My screen just clicks, goes black and then end up back where I started, not
>telling me that anything has been installed.
>
That sounds about right. A no-frills install...
--
Dale Earnhardt, Sr. R.I.P. 1951-2001
Homepage - http://www.umich.edu/~epickett
F1 hcp. +16.36...Monster +366.59...
Never argue with an idiot. He brings you down to his level, then beats you
with experience...
Remove SPAM-OFF to reply.
